Product Description
Jotul Gas Stove Blower Kit - GF 100DVII - GF 200 DVII
OEM Jotul Part #155631
For use in the below models only:
- Jotul GF 100 DVII
- Jotul GF 200 DVII
Blower Installation
1. Unpack and check the contents of the blower kit. There is a steel bracket that is not used with the GF 200 stove. Contact your dealer if any damage is evident or parts are missing. See fig. 51.
2. Attach the Control Box to the lower pair of holes on the Snapstat Bracket with two #8 x 1/2” sheet metal screws as shown in figs. 51 and 52.
3. Attach the Control Box assembly to the studs located underneath the stove in the middle of the firebox floor using two M6 hex nuts and a 10 mm socket driver or wrench. See fig. 52.
4. Use two M6 hex nuts to attach the Blower to the mounting holes at the rear of the stove bottom plate.
5. Connect the power cord to 110 AC house current.
Blower Operation
The variable-speed blower will enhance heat circulation around the firebox and out into the room. The blower is controlled by a heat activated switch (snapstat) that will function only when the control switch is in the AUTO setting. After the fire has been burning for a time, the snapstat will react to the heat and activate the blower. Fan speed may be manually adjusted with the rheostat knob. If the burner turns off, the blower will be shut off automatically as the stove cools down. If automatic blower circulation is not desired, place the blower control switch in the MANUAL position. That will override the snapstat, allowing the blower to run continuously.
Includes
- Blower
- Snapswitch Wire Harness
- Control Box
- Snapstat bracket
- Rheostat knob
- Snapswitch
- Mounting Bracket (GF100 DV II only)
- M6 flange nuts (2)
- M6 x 12 Hex Bolts (2)
- #8x1/2" Sheet metal screws (2)
