Product Description
HearthStone HIII (H3) Wood Stove - Gasket Kit
Assembly #93-58301
ASSEMBLY CONTENTS:
¼” Low Density Rope Gasket (7ft)
¾” Tape Gasket
Gasket Glue
BEFORE YOU BEGIN: Work with a cool stove.
1) Open the front door and lift it straight up and off from the stove. Place it face down on a table, workbench, or another smooth surface. Protect an enameled finish with cardboard or similar protection. Apply penetrating oil to the four bolt head that are retaining the glass frame.
2) Pull the worn gasket out of the gasket channel. Clean the debris out of the channel with the wire brush or steel wool. Wipe clean with a damp cloth
Note the placement of each of the bolts – occasionally oversized bolts were used. After the retention bars are removed, carefully lift the glass out and pull off the existing tape.
4. Cut the new flat gasket tape into 2 equal pieces, one for each door. Pull the paper backing off the new gasket (a little at a time works best). The adhesive side is applied to the glass overlapping each side of the glass. Continue around the glass until the entire glass is wrapped with the tape. Cut off any excess. Repeat on the other glass panel.
5. Place the glass panels back into the doors. Lay the retention straps back into place and secure with the screws.
6. Place the doors back onto the stove and tap the hinge pins back into place. Close the doors immediately and allow the gasket glue to dry (do not open for about an hour).
</span
